| Versatility- A single unit for push or pull applications
| - 12VDC high speed operation |
| - 22 lbs force at min stroke, 10 lbs at max stroke, 25 lbs holding (without return spring) |
|
- 12 lbs force at min stroke, 6 lbs at max stroke, 13 lbs holding (with return spring) |
| - Continuous duty rated |
| - 52 amps inrush, 1.5 amps holding current @ 12VDC |
| - Will operate at any stroke less than maximum (1") |
|
- Unit comes complete with return spring, rubber boot, threaded shaft and nut |
|
- 24 oz shipping weight |
Application notes:
|
- Energize Coil should not be energized for longer than 15 seconds to avoid coil damage |
|
- Precautions should be taken to avoid overheating Energize Coil via proper wiring/switching setup and/or use of SD85 Energize/Hold control relay |
|
- Allow 15 minutes cooling time between activations of the Energize Coil (less for shorter energize coil cycles) |
|
- Energize Coil must fully seat the plunger to allow Hold Coil to function properly |
| - Do not mount with boot down (unit is recommended for horizontal application only) |
|
- Do not apply grease or lubrication to parts |
| - Use minimum 10 AWG wire size as noted in wiring diagram and keep wire lengths to a minimum |
| - Caution: The solenoid housing is hot to the touch. A temperature rise to 185°F (85°C) is permissible |
|
